Panther Outboard Tilt/Trim Support Up To 300HP

It fits a single ram tilt/trim motor and helps prevent the outboard from dropping into the down position, reducing the risk of damage to the skeg or propeller.
Suitable for most outboard motors between 50hp and 300hp, the support features a 19mm inner slot. Be sure to check your trim ram diameter, as some motors may have rams too small for a secure fit.

• Assists in dampening the load on the tilt assembly
• Has been tested up to 300hp 4-stroke outboards
• 4 locking internal tabs to clip over tilt shaft
• Machined ends to allow for extra grip
• Can be cut shorter
• Material: Polyurethane 90A
• Colour: Neon Green
• Shaft diameter: 19mm
• Dimensions: 55(h) x 70(w) x 120(d) mm